- Smooth texture for beautiful tile joint
- Good durability and bonding strength without cracking
- Easy to clean
- Long lasting
- Both interior and exterior usage
- Joint width 1-7 mm
- Colors : 39
|Compressive Strength in standard condition after 28 days||≥ 15.0 N/mm2||20.6 N/mm2|
|Flexural Strength in standard
condition after 28 days
|≥2.5 N/mm2||4.7 N/mm2|
After 30 minutes
After 240 minutes
≤ 2.0 g
≤ 5.0 g
|Shrinkage||< 3.0 mm/m||1.16 mm/m|
|Abrasion Resistance||≤ 1000 mm3||457 mm3|
|Bucket life at 21 oC||–||6 hrs|
Standards: TCVN 7899-4:2008, ISO 13007-4:2013
1Mpa = 1 N/mm2 = 10 bar ~ 145 psi
All the above tests are carried out in the laboratory condition, actual
installation may give different test results depend on site condition.
Clean and remove any dirt or contaminations remaining in the joints. Make sure the joints are clean and dry before grouting.
Mix 1 kg of grout powder with 0.35-0.38 liters of clean water, or 2.5 parts grout to 1 part water (by volume). Add the grout into the water and mix well by hand or low speed drill. Allow the grout to
slake for 10 minutes, then remix. The mix should be stirred intermittently during application. Do not add water or grout after this point. If the grout has become too stiff to work, discard it and make a
Apply grouting after 24- 48 hour tile installation. Grout all areas by filling the joints with grout, then using a rubber face trowel and working diagonally across the grout joints. Remove all excess grout with the trowel. After 2 hours, clean tile surfaces with wet sponge and clean cloth.
During the first 72 hours, care should be taken to prevent the grout from drying out, by covering the installation with natural kraft paper.
Plastic sheeting or newspaper should not be used.
After 10 days, the area may be re-cleaned to remove any remaining grout from the surface of the tile. Scrubbing the floor with hot water and soap works best. It is not recommended that acids be used, as this cause color alteration of the grout joint. If necessary, test in an inconspicuous place first.
- May be harmful to the eyes, skin, or lungs. Wear suitable protective clothing, gloves, and eye/face protection
- In case of contact with eyes, rinse immediately with water and seek medical advice.
- After contact with skin, wash immediately with water
- Keep out of reach of children
Lasts up to one year if kept dry and away from heat, in a sealed bag.
2 kg / 2 Parts/ Bucket
Including Part A : 520 g, Part B : 1,480
CALCULATING CONSUMPTION[CP_CALCULATED_FIELDS id=”14″]